It is absurd how most people rush in auto shows for them to buy the best car in the market, with little or literally no idea of what a car is. This are the very same people who complain a lot, saying that owning a car is expensive even when compared to the use of public transport. It is embarrassing for a car owner who cannot even change a flat tire in the middle of nowhere.
It is central for any car owner to learn how to perform some of the minor repairs and also have some auto body diagnostic skills, which can be used to identify a problem. With this knowledge, it makes it harder for potential or possible scammers to steal from the clients in the market. Even though professional dent repair is important, it is uneconomical for a person to take a few minor dents to an auto body shop seeking professional services. Thus, every car owner should have at least some idea of how to repair a dent, using locally available materials such as a hair dryer. Here are some of the most basic steps which can be observed.
a. Inspecting the auto body to identify the affected areas is central and inevitable. The best method to use when identifying the dents is to start from the small, to medium sized to large dents. In case of hail damage repair, one might want to consider professional services, for quality results. Dent examination should be done carefully so as to identify all the faults. For further informations about hail damage repair in Sunshine Coast, check this out.
b. One should then obtain all the necessary materials required in the process of dent removal. Here is a list of these materials.
- A hair dryer whose temperatures can be adjusted
- Heavy duty insulated gloves
- A full can of compressed air
- A package of dry ice
- Aluminum foil
c. Apply heat on the dent. Using the hair dryer, the heat should be applied onto the dent, by blowing hot air over the point of interest. This should be done for approximately two consecutive minutes. Overheating the point of contact should be avoided to prevent the cases of overheating, which can damage the paint.
d. Lag the dented areas of panel, only where it is possible. The aluminum foil should be placed on the dented area. This should however be performed only when dry ice is being applied. The main aim of this step is to keep the dented area warm, while at the same time protecting the car paint from possible damage by dry ice.
e. Put on gloves, to protect oneself from possible injuries during the application of frostbite or any other injuries which can in the process of dent elimination.
f. Apply dry ice or liquefied and compressed air. The rapid temperature change causes the panel to expand and the contract, when cooled.
g. After the above step, wait for a few minutes after the application of dry ice. A pop sound may be heard indicating the dent has been removed.
h. Repeat the above steps on other dents till the rest of the auto body is straight and free from dents.